Hi,
I have this problem with setting up a distributed switch, and I am sure I am missing something!
I have a couple hosts with 4 physical NICs each. On eash host I have configured 2 virtual switches (say A and B), with 2 physical nic per vSwitch in etherchannel mode. Everything works fine for etherchannel and Route Based on IP Hash for these.
Recently I decided to create two distributed switches, and move respective physical ports from virtual switches to this distributed switches. Again I want to configure etherchannel and route based on ip hash. But when I open settings for uplink port group, the policies for Teaming and Failover are greyed out and cannot be changed. They apparently inherit configuration from somewhere else but I do not know where!
