I have just setup a new Dell PE740 host running ESXI 6.7 u1. Very small network with a single subnet and the host will only run about 5 VMs currently. My question is regarding the initial network setup on the host. I have 3 NICs connected and assigned to vSwitch0. In this switch, I have two port groups. One for VM Network and one for Management Network. The Management Network does currently have an active port that connects to the physical NICs. However, the VM Network port group has no active ports to this same NICs. And I cannot figure-out how to make the change for the VM Network. The interface and menus for ESXI 6.7 are quite different than 5.5 and 6.0 that I've worked with in the past.
Thanks for any input.
Ken
